Register
Once the Sinefa Probe has launched, log into it using SSH then run the following command:
sudo /opt/sinefa/bin/sinefa-set-config -r <registration key>
Your registration key can be found when you login to your Sinefa account and navigate to Settings | Software section.
After running this command, your new Sinefa Probe will appear under your account immediately.
Update
Updating the Sinefa service is easy, simply follow the instructions below for your operating system.
YUM
For operating systems that use YUM, run the following command.
yum update sinefa*
See Also
How are quality metrics measured?
How to Setup Network Quality Scoring (NQS)
Comments
0 comments
Please sign in to leave a comment.