This pre-installation checklist is used prior to deploying Sinefa into the network.
Section 1: Background Information
1.1) Outcomes
Please define the outcomes being seeked by deploying the Sinefa solution. Be as detailed as possible:
1.2) Network Topology / Diagram
Please outline the network topology or add a network diagram. Be sure to include things like the number of sites, locations, network type (MPLS, Internet, etc) and other relevant details which will help make the deployment as smooth as possible.
Section 2: Probe Configuration
2.1) Site Name
Use this as the Probe name under Settings - Probes
2.2) Bandwidth Throughput
( ) up 100Mbps
( ) up to 1Gbps
( ) over 1Gbps
2.3) Deployment Mode
( ) Inline (DEFAULT)
( ) Out-of-path
If Inline, where should the IP Address on the Probe be setup:
( ) IP Address on same bridge as the data path (DEFAULT)
( ) IP Address on a separate management port
( ) IP Address on a separate management port
2.4) IP Address
( ) DHCP (DEFAULT)
( ) Static Address
Management IP Address:
Subnet Mask / Prefix:
Default Route:
Primary DNS Server:
Secondary DNS Server:
2.5) Internet Access / Web Proxy
( ) No proxy required for internet access (DEFAULT)
( ) Proxy required
Web Proxy Address:
Web Proxy Port:
Web Proxy username:
Web Proxy password:
2.6) Ethernet Negotiation
( ) Auto (DEFAULT)
( ) Manual
Speed:
Duplex:
2.7) Ethernet Media
( ) 1Gbps copper - 1000BASE-T (DEFAULT)
( ) 1Gbps multi-mode fibre - 1000BASE-SX
( ) 10Gbps copper - 10GBASE-T
( ) 10Gbps multi-mode fibre - 10GBASE-SR
( ) 10Gbps single-mode fibre - 10GBASE-LR
2.8) VLAN Tag for Internet Access
( ) None (DEFAULT)
( ) Yes - VLAN ID:
Comments
0 comments
Article is closed for comments.